Partzman,
thanks, i included severall of these .IC statements for all 3 L's in the circuit, but it won't force it into oscillating.
Never mind, i will continue with the real circuit as that one is equally difficult to get into oscillating.
When it does oscillate however, the input will be around 24V / 100mA (and climbing) and the output will be an unloaded 200V. When loaded with say 10K, the output drops to 21V or so, so it has very little power.
I can make some nice sparks with a 250V/100uF cap, but up till now it acts like a low power boost converter (24V / 200V).
Perhaps with the right transistor it will change.
Itsu
Hi all re Itsu, you didnt wast much time with NELSONS DEVICE (promised I would promote his device he invented) I'm not sure you have got the idea right as I didn;t have much trouble getting any of the device to work at all I couldn't get any of the wound components off the shelf and had to wind my own and your right it is very low power. I think I know where your going wrong you need to put the bulb or LED back in the + feed and shunt it with a 150 ohm or you cant see whats going on, secondly what's that 20 M in the emiter circuit ? how did you arive at that value ? Show me if you can emiter and output drive shot the output choke circit diode end if you can that way i can tell you whats wrong. regards AG PS i forgot to put electrolytic across supply note blue led glows, now draws less current and no longer glows. Note I wouldn't say its over unity though!
« Last Edit: 2020-04-14, 09:29:58 by AlienGrey »
---------------------------
Be aware I'm moderated because I complained about persistent trolls to Chet, folowing me round and got same treatment as perpetrators..This is the third time, You aint doing this again.
|