Print Page - Home Made 3D Printer

Title: Home Made 3D Printer
Post by: Tommey Reed on 2014.12.11, 04:36:38

Hi All,

I wanted to 3d print this 2014 pulse motor build off, but I still have to calibrate it.

This is my 3D printer:

https://www.youtube.com/watch?v=PHldG8atIWY

Tom O0

Title: Re: Home Made 3D Printer
Post by: Tommey Reed on 2014.12.11, 23:22:47

Hi All,

Did a little calibration on marlin software, I think this is not bad at all.

My heat was a little too high, but it's alive :P

https://www.youtube.com/watch?v=4ISSi_7LK0A

Tom

Title: Re: Home Made 3D Printer
Post by: Tommey Reed on 2014.12.12, 18:46:26

Hi All,

Just about ready to print some good 3d parts.

https://www.youtube.com/watch?v=QBd35AfQtg0

Tom O0

OverUnity Research

General - Free Energy Related => Miscellaneous Discussions => Topic started by: Tommey Reed on 2014.12.11, 04:36:38