Electrical / Electronic Devices > Tariel Kapanadze's Devices

Kapanadze / Dally

<< < (4/4)

ion:

--- Quote from: tinman on 2013-03-31, 15:37:25 ---I found this video on YT about a new kapanadze device that has been built in Turkey.
The P/in and P/out look way to good to be true?
http://www.youtube.com/watch?v=KtadR0skY00

--- End quote ---

That video has been around for a while.

Where do you see power in / power out measurements? I only see a clamp amp meter being used. Without knowing the voltage on each side as well as current, we cannot know the power.

Am I missing something?

tinman:

--- Quote from: ION on 2013-03-31, 16:22:00 ---That video has been around for a while.

Where do you see power in / power out measurements? I only see a clamp amp meter being used. Without knowing the voltage on each side as well as current, we cannot know the power.

Am I missing something?

--- End quote ---
No nothing being missed ION.
I was going on the input wireing,which looked to be single phase and i believe 230/240 volts over there.The output to the electric motor looked to be 3 phase,as it had 4 wire's going to the motor(and very thick aswell)
Then they were also driving all the light's,and heating elements aswell.All of this couldnt have been drawing from a single circuit breaker from a 240 volt single phase supply.

But as you say,no where near enough information given to make any accurate measurement's-just my guessing here from what i could see in the video.
Like i said-way to good to be true.

Grumpy:
hmm

gaps are after the coils - at the top of them

could it be that simple?

TutorialFE:
Wesley News

http://www.youtube.com/watch?v=_NVBiY13osE&list=UU1ZrGlkxBvG9WOwIs2eApLA

Navigation

[0] Message Index

[*] Previous page

Go to full version