A switch, basically. A “ Morse code key “
I too dabbled a little with this device but my problem was electronically matching the switches to suit the opposite polarities. I often wondered whether this could be achieved by using one of the Arduino type thingies driving opto or electromagnetic reed switches. Would the effect manifest at low switching frequencies?
Cheers Grum
As a post script, has anyone run the circuit through simulation software?
If that’s the case as I suspected, then I would think that device VT3 would be better placed on the neg side of the output diode, the other thing is on the drawing i have all the windings shown in series shouldn’t two of them be inductive canceling mode. Ive not tried that mode yet. Sil
« Last Edit: 2023-10-19, 02:11:30 by AlienGrey »
---------------------------
Be aware I'm moderated because I complained about persistent trolls to Chet, folowing me round and got same treatment as perpetrators..This is the third time, You aint doing this again.
|