To Ion I'm very aware of the Dr. Schinzinger's reports I believe that was done because the investor didn't trust SM and wanted a serious evaluation.
I have worked on SM stuff since Jack Durban was on overunity.com the thing that worked for me was what,Jack Durban said of SM,"he lies even when he doesn't need to". I concluded that everything SM said is a half truth, flat out lie or a depiction of something that he discovered,but twisted. SM has been and is on these news groups,to confuse and misdirect,I believe it has something to do with the deal with the company he sold the rights to(now this my theory)anyone figures out how it works and bulids it he loses hes income or possibly gets killed,its unknown what deal he did or if the military is involved. I don't trust our US government,your right the videos are the key to making this device,however SM threw in things to confuse the engineers that the investors brought in.On the inverter video,think simple,in the inverter video the simplest way is hollow out the big transformer,use a 12 volt sealed lead acid battery,use a small inverter(was sold at radio shack at that time,225 watts continuous,over 300 watts,5 min) pop out the on/off switch of the inverter,use a dpdt ac relay from (radio shack]wire the switch to the relay,check which connections turn on the inverter. Now wire the coil connections to the triplitt inverter input connections then your set to go,I would wire the battery to some hidden wires to recharge the battery. When you apply a hv dc voltage to the relay, the relay will turn on the inverter the inverter will power up the drill,vacuum and tv The illusion is the tpu powered the tv,vacuum,drill.The 6 inch tpu used is real,it powering the appliances is not. There was a constant flow of investors ,with engineers they would bring in there own light bulbs, meters,and looked at all angles of fraud.An investor will not give you a penny there greedy bastards if it didn't work, this fact is absolute proof that the 17 inch tpu worked in my book,the investors were big players.
Heres something for you,you know in the video with the 17 inch tpu when he measures the current and everybody says he didn't measure the current correctly,hes not measuring a dc current but a pulsing dc magnetic field across the back part of the tpu,across the opening,The meter can detect a 10hz to 10khz pulsing dc magnetic field,I made a coil in a circle with an opening the coil is driven by a signal generator fed to a power amp of 400 watts,I measured with an iron core and without an iron core.With an iron core i got readings from the meter the same amount as on the video,without a core nothing or very little.I went from 10hz to 10khz on the frequency, I set the meter exactly as the tpu video,the meter at this dc setting does not react to ac magnetic fields,tried that know for sure. Theres a good chance that the tpu has a iron or ferrite core,the vibration reported is most likely in the range of 10hz to 400hz. As you pass 400hz the vibration slowly disappears.The tpu is very hard to figure out so every small clue helps.
|